UniMed Cut Off Marks 2020/2021 — JAMB & Post UTME

The university of medical sciences, UniMed cut off mark for this year’s admission is out. UniMed JAMB and direct entry cut off point for all courses is here.

If you chose the institution as your first choice in 2020 Joint Admissions and Matriculation  Board (JAMB) then this article will be helpful to you.

The JAMB mode of admission will allow you get admission into any school of your choice if you meet your program cut off. To be fully eligible for admission, you need to meet all requirements.

This includes,

  • Upload your O’level on JAMB Caps
  • Meet cut off mark for the course you want to study
  • Have good jamb result
  • Be at least 16 years

UniMed JAMB Cut Off Mark

The joint admissions and matriculation board (JAMB) usually set fixed cut off marks for Polytechnics and universities

As per University of medical sciences (UniMed) Ondo State, the approved cut off mark for JAMB is 180. Any candidate that scored 180 or above is eligible for admission in UniMed. Moreover, the higher your score, the higher your chances of getting admission.

UniMed Departmental Cut Off Points / Marks

This is another important criteria every candidates must know. The cut off point doesn’t end in JAMB. This type of cut off mark is usually set by school and it is very important for admission. The cut off mark will be solely depend on general performance of candidates during Post-UTME screening.

As at the time of writing this article, UniMed (university of medical sciences Ondo State) is yet to release cut off marks for this year’s (2020/2021) admission.

However, any candidate with good results will be considered for admission.

Notice: We will publish UniMed courses and their cut off marks here. Kindly check back later for updates.

If you have any query or need more academic consultancy, kindly post your comments below. We will be glad to help you with more information.

Good luck to all aspirants!.

2 Comments

  1. Motunrayo June 21, 2020
  2. bamidele israel May 24, 2020

Leave a Reply

error: Content is protected !!